Built-In Microwave Ovens
MD and MDD-series units set into cabinetry, 24" and 30".
Wolf Microwaves
Built-in and drawer microwaves are cabinetry as much as appliance — a door that stops closing squarely takes the whole unit out. Our Wolf technician separates the door, the controls and the high-voltage side before quoting anything.
Coverage
Built-ins, drawers, convection models and units stacked into oven columns. If your model isn't listed, call anyway — the fault matters more than the badge.
MD and MDD-series units set into cabinetry, 24" and 30".
Pull-out drawer units built into islands and base cabinets.
Combination cavities that cook with microwave and convection together.
Units stacked above or below a wall oven in one tall cabinet.
Units framed into cabinetry with a trim kit, where access is planned first.
Both trim families, with their different door hardware and control panels.
Units well past warranty, where parts have to be sourced rather than pulled off the van.
What We Fix
Tell us which of these matches on the phone. On a Wolf microwave the symptom usually says whether the fault is the door, the controls or the high-voltage side before our technician reaches your address.
Everything looks normal — light, fan, timer — and nothing heats. The magnetron, the high-voltage components or a door switch that never tells the unit it's safe to fire.
Worn hinges, a damaged latch, or mounting hardware that has shifted. On a built-in the cabinet takes some of the load, so alignment drifts over the years.
Usually thermal protection doing its job: a cooling fan that's slowed down, a blocked vent, or a sensor cutting the cycle short.
Control board, display module, or the supply feeding the unit. Note the code before you call — it shortens the visit.
Some buttons work and others don't, or the panel responds when cold and stops when warm. Membrane or control board, and the two behave differently.
Drive motor, coupler, or the roller ring underneath. Food heating unevenly with everything else normal usually starts here.
The cooling fan, the turntable drive, or a magnetron under strain. A microwave that got noticeably louder is worth looking at before it stops.
An item that cooked far past its limit can affect the cavity, the door switches and the wiring behind them. Worth an inspection even if the unit still powers on.
Describe what the microwave does and when. Most Wolf faults are identifiable over the phone in a couple of minutes.
Recent Repairs
Real Wolf microwaves, real faults, real replaced parts. Each of these repairs started as a call that sounded like the symptom you probably have right now.
A microwave door is not just a lid: the interlock switches behind it decide whether the unit will run at all. A door that has to be pushed or lifted is worth fixing before those switches stop registering it as closed.
This is the view behind the panel: fan, transformer and the high-voltage side. Heat from something cooking far past its limit reaches those parts as well as the cavity, which is why an inspection is worth doing even when the microwave still switches on.
A microwave that runs without heating is the most common call on this appliance. The light, fan and timer all sit on a different circuit from the part that actually cooks — so everything looking normal tells you almost nothing until the high-voltage side is measured.
Book It
Call and describe the symptom — not heating, door sticking, error code — or leave your number and a dispatcher will call you back with a time window.
Service Areas
We repair Wolf microwave built-ins across these metro areas, with same-day appointments in most of them when you call before noon.
Don’t see your city? Call (404) 474-1374 and we’ll tell you whether we reach you.
Pricing
No hidden fees, and nothing starts until you approve a firm quote.
Other Appliances
Questions